Power Failure; Management Options; Web-Based Management Interface - D-Link SmartPro DGS-1510-28XMP Getting Started Manual

Power Failure

case of power failure. When power is resumed, plug the
switch back in.

Management Options

This system may be managed out-of-band through the
Telnet. The user may also choose the web-based
management, accessible through a web browser. Each
used for communication with an SNMP network manager
can change the default Switch IP address to meet the

Web-based Management Interface

the switch, monitor the LED panel, and display statistics
graphically using a web browser, such as Microsoft
Internet Explorer version 7.0 and higher, Firefox, Chrome
or Safari.
You need the following equipment to begin the web
•
•
Step 1
Connect the Ethernet cable to any of the ports in front
panel of the switch and to the Ethernet port on the PC.
Figure 7. Connected Ethernet cable
Step 2
connection, the PC must have an IP address in the same
range as the switch. For example, if the switch has an
IP address of 10.90.90.90, the PC should have an IP
mask of 255.0.0.0.
https://tm.by
Интернет-магазин TM.by
press <Enter>.
Figure 8. Enter the IP address 10.90.90.90 in the web
browser
Step 3
When the following logon dialog box appears, enter
®
choose the language of the Web-based Management
interface then click Login.
Step 4
Before entering the Web-based Management, the
Smart Wizard
functions, such as Ip Information, User Account and
SNMP Settings
click Exit to exit the Wizard and enter the Web-based
functions, please refer to the Smart Wizard introduction
in the user manual.
NOTE:
address is 10.90.90.90 with a subnet
mask of 255.0.0.0 and a default
gateway of 0.0.0.0