Layer 3 Features; Arp; Arp Elevation; Arp Aging Time - D-Link DGS-3130 Series Web Ui Reference Manual

DGS-3130 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
6.

Layer 3 Features

ARP

Gratuitous ARP
IPv6 Neighbor
Interface
UDP Helper
IPv4 Static/Default Route
IPv4 Route Table
IPv6 Static/Default Route
IPv6 Route Table
Route Preference
ECMP Settings
RIP
RIPng
IP Route Filter
Policy Route
VRRP Settings
ARP

ARP Elevation

This window is used to display and configure the Address Resolution Protocol (ARP) elevation state. This is used to
allow all ARP traffic to the Switch where the destination is the Switch itself. This traffic will take a higher priority than
other ARP packets.
To view the following window, click L3 Features > ARP > ARP Elevation, as shown below:
The fields that can be configured are described below:
Parameter
ARP Elevation State
Click the Apply button to accept the changes made.

ARP Aging Time

This window is used to display and configure the ARP aging time settings.
To view the following window, click L3 Features > ARP > ARP Aging Time, as shown below:
Figure 6-1 ARP Elevation Window
Description
Select to enable or disable the ARP elevation feature here.
183