Lldp Transmit - D-Link DGS-510 Reference Manual

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
Switch# configure terminal
Switch(config)# interface ethernet 1/0/1
Switch(config-if)# lldp tlv-select
Switch(config-if)#
This example shows how to enable advertising the system name TLV.
Switch# configure terminal
Switch(config)# interface ethernet 1/0/1
Switch(config-if)# lldp tlv-select system-name
Switch(config-if)#
43-14

lldp transmit

This command is used to enable the LLDP advertise (transmit) capability. Use the no form of this
command to disable LLDP transmission.
lldp transmit
no lldp transmit
Parameters
None.
Default
By default, LLDP transmit is enabled on all supported interfaces.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is available for physical port configuration. This command is used to enable LLDP
transmission on a physical interface. When LLDP is not running, the Switch doesn't transmit LLDP
messages.
Example
This example shows how to enable LLDP transmission.
Switch# configure terminal
Switch(config)# interface ethernet 1/0/1
Switch(config-if)# lldp transmit
Switch(config-if)#
43-15 lldp tx-delay
This command is used to configure the transmission delay timer. This delay timer defines the
minimum interval between the sending of LLDP messages due to constantly changing MIB content.
Use the no form of this command to revert to the default setting.
lldp tx-delay SECONDS
no lldp tx-delay
375