Pim Register Checksum Settings - D-Link xStack DGS-3324SRi User Manual

xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch User Manual
The following fields can be viewed or set:
Parameter
Group Address
Group Mask
Interface Name
Click Apply to implement changes made.

PIM Register Checksum Settings

This window is used to set a first hop router to create checksums to be included with the data in Registered packets. To
view this window, click Configuration > Layer 3 IP Networking > IP Multicast Routing Protocol > PIM Protocol >
PIM Register Checksum Settings.
Figure 6- 177. PIM Register Checksum Include Data RP List Settings window
To configure the settings for this window, click the Add button, which will reveal the following window for the
administrator to configure.
Figure 6- 178. PIM Register Checksum Include Data RP List Settings - Add window
The following fields can be set:
Parameter
RP Address
Click Apply to set the RP as a checksum enabled router.
Figure 6- 176. PIM Candidate RP Settings – Add window
Description
Enter the multicast group address for this CRP. This address must be a class D
address.
Enter the mask for the multicast group address stated above.
Enter the name of the PIM-SM enabled interface the switch administrator wishes to
become the CRP for this group.
Description
Enter the IP address of the RP that will verify checksums included with Registered
packets.
210