Port Role Configuration With The J-Web Interface (With Cli References) - Dell PowerConnect J-EX4200-24T Software Manual

Port Role Configuration with the J-Web Interface (with CLI References)

Table 125: Port Role Configuration Summary
Configuration Description
Default Port Role
Set the port role to .
Default
Set port family to
ethernet-switching
Set port mode to .
access
Enable RSTP if redundant trunk groups are not
configured.
Disable RSTP if redundant trunk groups are
configured.
Desktop Port Role
Set the port role to desktop.
Set VLAN if new VLAN is specified.
Set port family to ethernet-switching
Set Port Mode to Access .
Set VLAN if new VLAN is specified.
Set port security parameters.
Set RSTP protocol with
edge
J-EX Series Switches Interfaces Overview on page 863
Junos OS CoS for J-EX Series Switches Overview on page 2860
Understanding Interface Naming Conventions on J-EX Series Switches on page 865
When you configure Gigabit Ethernet interface properties with the J-Web interface
(Configure > Interfaces) you can optionally select pre-configured port roles for those
interfaces. When you select a role from the
interface modifies the switch configuration using CLI commands. Table 125 on page 915
lists the CLI commands applied for each port role.
NOTE: If there is an existing port role configuration, it is cleared before the
new port role configuration is applied.
CLI Commands
set interfaces interfaceapply-macro juniper-port-profile
Default
.
set interfaces interface unit 0 family ethernet-switching
port-mode access
delete protocols rstp interface interface disable
set protocols rstp interface interface disable
set interfaces interface apply-macro juniper-port-profile
Desktop
set vlans <vlan name> vlan-id <vlan-id>
. set interfaces interface unit 0 family ethernet-switching
port-mode access
set interfaces interface unit 0 family ethernet-switching
vlan members vlan-members
set ethernet-switching-options secure-access-port vlan
MacTest arp-inspection
option. set protocols rstp interface interface edge
Chapter 52: Configuring Interfaces
field and apply it to a port, the J-Web
Port Role
915