Primary; Policing - Juniper JUNOS OS 10.3 - SOFTWARE Manual

Complete Software Guide for Junos

policing

Syntax
Hierarchy Level
Release Information
Description
Options
Required Privilege
Level
Related
Documentation

primary

Syntax
Hierarchy Level
Release Information
Description
Options
Required Privilege
Level
Related
Documentation
3428
®
OS for EX Series Ethernet Switches, Release 10.3
policing (filter filter-name | no-automatic-policing);
[edit protocols mpls label-switched-path lsp-name]
[edit interfaces interface-id unit number-of-logical-unit family inet address ip-address]
Statement introduced in Junos OS Release 10.1 for EX Series switches.
Apply a rate-limiting policer as the specified policing filter:
To the LSP for MPLS over CCC.
To the customer-edge interface for IP over MPLS.
—Specify the name of the policing filter.
filter filter-name
no-automatic-policing —Disable automatic policing on this LSP.
routing—To view this statement in the configuration.
routing-control—To add this statement to the configuration.
policer on page 3111
Configuring Policers to Control Traffic Rates (CLI Procedure) on page 3073
Configuring CoS on MPLS Provider Edge Switch Using Circuit Cross-Connect (CLI
Procedure) on page 3223
Configuring CoS on MPLS Provider Edge Switch Using IP Over MPLS (CLI Procedure)
on page 3222
primary path-name;
[edit protocols mpls label-switched-path lsp-name]
Statement introduced in Junos OS Release 9.5 for EX Series switches.
Specify the primary path to use for a label switched path (LSP). You can configure only
one primary path.
—Name of the primary path that you created with the
path-name
routing—To view this statement in the configuration.
routing-control—To add this statement to the configuration.
Configuring Path Protection in an MPLS Network (CLI Procedure) on page 3391
statement.
path
Copyright © 2010, Juniper Networks, Inc.