Juniper JUNOS OS 10.3 - SOFTWARE Manual page 3493

Related
Documentation
Copyright © 2010, Juniper Networks, Inc.
Configure an IP address for the loopback interface and for the core interfaces:
5.
[edit]
user@switch# set interfaces lo0 unit 0 family inet address 127.1.1.1/32
user@switch# set interfaces ge-0/0/5 unit 0 family inet address 10.1.5.1/24
user@switch# set interfaces ge-0/0/6 unit 0 family inet address 10.1.6.1/24
user@switch# set interfaces ae0 unit 0 family inet address 10.1.9.2/24
Configure on the logical units of the core interfaces:
6. family mpls
[edit]
user@switch# set interfaces ge-0/0/5 unit 0 family mpls
user@switch# set interfaces ge-0/0/6 unit 0 family mpls
user@switch# set interfaces ae0 unit 0 family mpls
NOTE: You can enable
aggregated Ethernet interfaces. You cannot enable it on tagged VLAN
interfaces.
Example: Configuring MPLS on EX Series Switches on page 3365
Configuring MPLS on Provider Edge Switches Using Circuit Cross-Connect (CLI
Procedure) on page 3405
Configuring MPLS on Provider Edge Switches Using IP Over MPLS (CLI Procedure) on
page 3401
Configuring an OSPF Network (J-Web Procedure) on page 1681
Understanding JUNOS MPLS Components for EX Series Switches on page 3353
Chapter 123: Configuring MPLS
on either individual interfaces or
family mpls
3397