Ping Mpls L2Circuit - Juniper JUNOS OS 10.3 - SOFTWARE Manual

ping mpls l2circuit

Syntax
Release Information
Description
Options
Copyright © 2010, Juniper Networks, Inc.
ping mpls l2circuit (interface interface-name | virtual-circuit virtual-circuit-id neighbor address)
<count count>
<destination address>
<detail>
<exp forwarding-class>
<logical-system (all | logical-system-name)>
<size bytes>
<source source-address>
<sweep>
<v1>
Command introduced before Junos OS Release 7.4.
Command introduced in Junos OS Release 9.0 for EX Series switches.
The size and sweep options were introduced in Junos OS Release 9.6.
Check the operability of the MPLS Layer 2 circuit connections. Type Ctrl+c to interrupt a
command.
ping mpls l2circuit
—(Optional) Number of ping requests to send. If
count count
requests are sent. The range of values is
5 .
—(Optional) Specify an address other than the default (
destination address
for the ping echo requests. The address can be anything within the
—(Optional) Display detailed information about the echo requests sent and received.
detail
exp forwarding-class —(Optional) Value of the forwarding class for the MPLS ping packets.
—Ping an interface configured for the Layer 2 circuit on the egress
interface interface-name
provider edge (PE) router.
logical-system (all | logical-system-name)
systems or on the specified logical system.
—(Optional) Size of the label-switched path (LSP) ping request packet (
size bytes
through 65468 bytes). Packets are 4-byte aligned. For example, If you enter a size
of 97, 98, 99, or 100, the router or switch uses a size value of 100 bytes. If you enter
a packet size that is smaller than the minimum size, an error message is displayed
reminding you of the 96-byte minimum.
—(Optional) IP address of the outgoing interface. This address is
source source-address
sent in the IP source address field of the ping request. If this option is not specified,
the default address is usually the loopback interface (
—(Optional) Automatically determine the size of the maximum transmission unit
sweep
(MTU).
v1 —(Optional) Use the type 9 Layer 2 circuit type, length, and value (TLV).
Chapter 126: Operational Mode Commands for MPLS
is not specified, five ping
count
through . The default value is
1 1,000,000
—(Optional) Perform this operation on all logical
lo.0 ).
)
127.0.0.1/32
127/8 subnet.
96
3439