2.2.11.2
exit | quit
Use either of these commands to leave a CLI session.
exit
quit
NOTE: By default, device timeout occurs after 15 minutes of user inactivity,
automatically closing your CLI session. Use the set logout command as described in
Section 2.2.3.32
When operating in router mode, the exit command jumps to a lower configuration level.
For details on enabling router configuration modes, refer to
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to exit a CLI session:
Matrix(rw)->exit
to change this default.
Matrix DFE-Platinum and Diamond Series Configuration Guide
General Configuration Command Set
Pausing, Clearing and Closing the CLI
Section
2.3.3.
2-149