Enterasys Matrix 2G4072-52 Configuration Manual page 163

2.2.9.4 configure
Use this command to execute a previously downloaded configuration file stored on the device.
configure filename [append]
Syntax Description
filename
append
Command Type
Switch.
Command Mode
Read-Write.
Command Defaults
If append is not specified, the current running configuration will be replaced with
the contents of the configuration file, which will require an automated reset of the
chassis.
Example
This example shows how to execute the "myconfig" file in the module in slot 1:
Matrix(rw)->configure slot1/myconfig
Specifies the path and file name of the configuration file to
execute.
(Optional) Executes the configuration as an appendage to
the current configuration. This is equivalent to typing the
contents of the config file directly into the CLI and can be
used, for example, to make incremental adjustments to the
current configuration.
Matrix DFE-Platinum and Diamond Series Configuration Guide
General Configuration Command Set
Managing Configuration and Image Files
2-137