Activating The Hydraulic Purge Using The Cab Display Module (Cdm) - MacDon M Series Unloading And Assembly Instructions

4.8.8 Activating the Hydraulic Purge Using the Cab Display Module (CDM)

The hydraulic purge removes air from the hydraulic pump system after it has been repaired or changed.
NOTE:
Engine MUST be running to perform this procedure.
1. Turn ignition key to RUN, or start the engine.
2. Press PROGRAM (A) and SELECT (C) on cab display
module (CDM) to enter Programming Mode.
• WINDROWER SETUP? is displayed on the
upper line.
147962
CAB DISPLAY MODULE (CDM)
Figure 4.327: M105 CDM Programming Buttons
Figure 4.328: M155 CDM Programming Buttons
Figure 4.329: M205 CDM Programming Buttons
293
Revision A