Testing The Rotary Disc Drive Circuit Activate Function Using The Cab Display Module (Cdm) - MacDon M Series Unloading And Assembly Instructions
Self-propelled windrower
Hide thumbs
Also See for M Series:
- Unloading and assembly instructions (95 pages) ,
- Assembly instructions manual (91 pages) ,
- Assembly instructions manual (117 pages)
Table of Contents
Advertisement
CAUTION
Check to be sure all bystanders have cleared the area.
7. Press SELECT (E) until REEL DRV SPD XXXX is
displayed on the upper line.
IMPORTANT:
Do NOT over-speed the reel.
8. Press and hold HAZARD (C) button.
• Press left (B) arrow to decrease reel speed.
• Press right (D) arrow to increase reel speed.
Verify the reel drive is functioning properly.
9. Release the HAZARD (C) button. The reel will stop.
10. Press PROGRAM (A) to exit Programming Mode or
press SELECT (E) to proceed to next ACTIVATE
FUNCTION.
4.8.12 Testing the Rotary Disc Drive Circuit Activate Function Using the
Cab Display Module (CDM)
IMPORTANT:
Do not over-speed a drive. Over-speeding can lead to vibration, belt failures, or other over-speeding related
problems.
NOTE:
• A rotary disc header MUST be attached to windrower to follow this procedure.
• The engine MUST be running to perform this procedure.
147962
CAB DISPLAY MODULE (CDM)
Figure 4.364: M155 Reel Drive
Figure 4.365: M205 Reel Drive
309
Revision A
Advertisement
Table of Contents
Troubleshooting
