Testing The Reel Drive Circuit Activate Function Using The Cab Display Module (Cdm) On An M105 - MacDon M Series Unloading And Assembly Instructions
Self-propelled windrower
Hide thumbs
Also See for M Series:
- Unloading and assembly instructions (95 pages) ,
- Assembly instructions manual (91 pages) ,
- Assembly instructions manual (117 pages)
Table of Contents
Advertisement
7. Press SELECT (C) until DRAPER/AUGER DRIVE ON
appears on the lower line.
8. Press and hold right (B) arrow to activate draper/auger.
Verify draper/auger is functioning properly.
9. Release right (B) arrow to deactivate draper/auger.
10. Press
PROGRAM
Mode or press SELECT (C) to proceed to next
ACTIVATE FUNCTION.
4.8.6 Testing the Reel Drive Circuit Activate Function Using the Cab
Display Module (CDM) on an M105
NOTE:
• The header MUST be attached to windrower to perform this procedure.
• The engine MUST be running to perform this procedure.
• An A40 or Draper Header is required to perform this procedure.
• Displaying reel speed on cab display module (CDM) requires installation of optional Expansion Module
(MD #B4666).
For more information, refer to the windrower operator's manual or the windrower
technical manual.
1. Turn ignition key to RUN, or start the engine.
2. Press PROGRAM (A) and SELECT (C) on cab display
module (CDM) to enter Programming Mode.
147962
CAB DISPLAY MODULE (CDM)
(A)
to
exit
Programming
Figure 4.310: Draper/Auger
Figure 4.311: CDM Programming Buttons
286
Revision A
Advertisement
Table of Contents
Troubleshooting
