Digi IX14 User Manual page 430

Services
1. Log into the IX14 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Enable the iPerf server:
(config)> service iperf enable true
(config)>
4. (Optional) Set the port number for the iPerf server listening port. The default is 5201.
(config)> service iperf port port_number
(config)>
5. (Optional) Set the access control list to restrict access to the iPerf server:
To limit access to specified IPv4 addresses and networks:
n
(config)> add service iperf acl address end value
(config)>
Where value can be:
l
l
l
Repeat this step to list additional IP addresses or networks.
To limit access to specified IPv6 addresses and networks:
n
(config)> add service iperf acl address6 end value
(config)>
Where value can be:
l
l
l
Repeat this step to list additional IP addresses or networks.
To limit access to hosts connected through a specified interface on the IX14 device:
n
(config)> add service iperf acl interface end value
(config)>
Where value is an interface defined on your device.
IX14 User Guide
A single IP address or host name.
A network designation in CIDR notation, for example, 192.168.1.0/24.
any: No limit to IPv4 addresses that can access the service-type.
A single IP address or host name.
A network designation in CIDR notation, for example, 2001:db8::/48.
any: No limit to IPv6 addresses that can access the service-type.
Display a list of available interfaces:
Configure the ping responder service
430