Configure Serial Authentication - Digi IX14 User Manual

User authentication
b. Enter the LDAP server's IP address or hostname:
(config auth ldap server 0)> hostname hostname|ip-address
(config auth ldap server 0)>
c. (Optional) Change the default port setting to the appropriate port:
(config auth ldap server 0)> port port
(config auth ldap server 0)>
d. (Optional) Repeat the above steps to add additional LDAP servers.
13. Add LDAP to the authentication methods. Authentication methods are attempted in the order
they are listed until the first successful authentication result is returned. This example will add
LDAP to the end of the list. See
methods to the beginning or middle of the list.
(config)> add auth method end ldap
(config)>
14. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
15. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Configure serial authentication

This section describes how to configure authentication for serial access.

WebUI
1. Log into the IX14 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
IX14 User Guide
User authentication methods
Configure serial authentication
for information about adding
225