Digi IX14 User Manual page 739

Hide thumbs Also See for IX14:

Table of Contents

more often than the default of 15 minutes.

Allowed values are any number of weeks, days, hours, minutes, or seconds, and take

the format number{w|d|h|m|s}. For example, to set Interval to five seconds, enter 5s.

iv. Click to expand Test targets > Test target.

v. Configure the test target. For example, to configure SureLink to verify internet

connectivity on the LAN by pinging my.devicecloud.com:

ii. For Ping host, type my.devicecloud.com.

11. Click Apply to save the configuration and apply the change.

Command line

1. Log into the IX14 command line as a user with full Admin access rights.

Depending on your device configuration, you may be presented with an Access selection

menu. Type admin to access the Admin CLI.

2. At the command line, type config to enter configuration mode:

3. Create a new VRRP instance, or edit an existing one. See

creating a new VRRP instance.

4. Enable VRRP+:

(config)> network vrrp VRRP_test vrrp_plus enable true

5. Add interfaces to monitor. Generally, this will be a cellular or WAN interface.

a. Use the ? to determine available interfaces:

(config)> network vrrp test interface ?

Interface: The network interface.

IX14 User Guide

i. For Test Type, select Ping test.

Virtual Router Redundancy Protocol (VRRP)

Configure VRRP

for information about