Command line interface
1. Enter the revert command with the path set to auth method:
(config)> revert auth method
(config)>
2. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
3. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access
selection menu. Type quit to disconnect from the device.
Move to the location in the configuration and enter the revert command without the path
n
parameter. For example:
1. Change to the auth method node:
(config)> auth method
(config auth method)>
2. Enter the revert command:
(config auth method)> revert
(config auth method)>
3. Save the configuration and apply the change:
(config auth method)> save
Configuration saved.
>
4. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access
selection menu. Type quit to disconnect from the device.
You can also use a combination of both of these methods:
n
1. Change to the auth node:
(config)> auth
(config auth)>
2. Enter the revert command with the path set to method:
(config auth)> revert method
(config auth)>
3. Save the configuration and apply the change:
(config auth)> save
Configuration saved.
>
IX14 User Guide
Configuration mode
795