Digi IX14 User Manual page 57

Initial configuration
4. Configure scheduled tasks:
Set the reboot time:
n
(config)> system schedule reboot_time time
(config)>
where time is the time of the day that the device should reboot, using the format
HH:MM.
Schedule maintenance tasks:
n
l
l
l
l
l
5. If you want to add custom scripts, see
information.
6. (Optional) Set the timezone for the location of your IX14 device. The default is UTC.
IX14 User Guide
Configure the time of day that the maintenance window should start, using the
syntax HH:MM. If the start time is not set, maintenance tasks are not scheduled and
will not be run.
(config system schedule maintenance trigger 0)> time from HH:MM
(config system schedule maintenance trigger 0)>
Configure the duration length (the amount of time that the maintenance tasks will
be run). If 0 is used, all scheduled tasks will begin at the start time as defined in the
previous step.
system schedule maintenance length num
(config)>
where num is any whole number between 0 and 24.
Configure the frequency that the maintenance tasks should be run:
system schedule maintenance frequency value
(config)>
where value is either daily or weekly. daily is the default.
Configure the device to look for any updated modem firmware during the
maintenance window. If updated firmware is found, it will then be installed. The
device will look for updated firmware both on the local device and over the
network, using either a WAN or cellular connection.
system schedule maintenance modem_fw_update value
(config)>
where value is either true or false. yes or no, and 1 or 0 are also allowed.
Allow for the configuration to be updated, including by custom scripts, during the
maintenance window:
system schedule maintenance config_check value
(config)>
where value is either true or false. yes or no, and 1 or 0 are also allowed.
Schedule system maintenance tasks
Configure system settings
for more
57