Digi IX14 User Manual page 372

Services
%s: Includes the IX14 device's serial number in the prepended text.
n
%v: Includes the vehicle ID in the prepended text.
n
For example, to include both the device's serial number and vehicle ID in the prepend
message, you can enter the following in the Prepend field:
__|%s|__|%v|__
14. Type a four-digit alphanumeric Vehicle ID that will be included with to location messages. If
no vehicle ID is configured, this setting defaults to 0000.
15. Click Apply to save the configuration and apply the change.

Command line
1. Log into the IX14 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Add a remote host to which location messages will be sent:
(config)> add service location forward end
(config service location forward 0)>
4. Set the hostname or IP address of the remote host to which location messages will be sent:
(config service location forward 0)> server host
(config service location forward 0)>
5. Set the communication protocol to either upd or tcp:
(config service location forward 0)> protocol protocol
(config service location forward 0)>
6. Set the TCP or UDP port on the remote host to which location messages will be sent:
(config service location forward 0)> server_port 8000
(config service location forward 0)>
7. Set the number of Location update intervals to wait before forwarding location data to this
server. See
update interval.
(config service location forward 0)> interval_multiplier int
(config service location forward 0)>
IX14 User Guide
Configure the location service for more information about setting the Location
Location information
372