Digi IX14 User Manual page 115

Interfaces

Command line
1. Log into the IX14 command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Enter the show network
> show network
Interface
----------------
defaultip
defaultlinklocal
LAN
LAN
loopback
modem
modem
>
3. Additional information can be displayed by using the
> show network verbose
Interface
Weight
----------------
----
defaultip
defaultlinklocal
LAN
LAN
loopback
modem
modem
>
4. Enter show network interface name at the Admin CLI prompt to display additional
information about a specific WAN. For example, to display information about LAN, enter show
network interface LAN:
> show network interface LAN
wan1 Interface Status
---------------------
Device
Zone
IPv4 Status
IX14 User Guide
command at the Admin CLI prompt:
Proto Status Address
----- ------- -------------------------------
IPv4 up 192.168.210.1/24
IPv4 up 169.254.100.100/16
IPv4 up 192.168.2.1/24
IPv6 up fd00:2704::1/48
IPv4 up 127.0.0.1/8
IPv4 up 10.200.1.101/30
IPv6 down
Proto Status Type
----- ------- ------
IPv4 up static
IPv4 up static
IPv4 up static
IPv6 up static
IPv4 up static
IPv4 up modem
IPv6 down modem
: LAN
: external
: up
Wireless Wide Area Networks (WWANs)
show network verbose command:
Zone Device
-------- --------
setup LAN
setup LAN
internal LAN
internal LAN
loopback loopback
external wwan1
external wwan1
Metric
------ --
10 10
0 10
5 10
5 10
0 10
3 10
3 10
115