Digi IX14 User Manual page 160

Allowed values are:
even
n
odd
n
none
n
The default is none.
9. Set the stop bits used by the device to which you want to connect:
(config)>path-paramstopbits bits
(config)>
10. Configure the session settings.
a. Set the characters used to start an escape sequence:
(config)>path-paramescape string
(config)
If no characters are defined, the escape sequence is disabled. The default is ~b.
b. Limit access to the serial port to a single active session:
(config)>path-paramexclusive true
(config)
c. Set the number of bytes of output from the serial port that are written to buffer. These
bytes are redisplayed when a user connects to the serial port.
(config)>path-paramhistory bytes
(config)
The default is 4000 bytes.
d. Set the amount of time to wait before disconnecting due to user inactivity:
(config)>path-paramidle_timeout value
(config)
where value is any number of weeks, days, hours, minutes, or seconds, and takes the
format number{w|d|h|m|s}.
For example, to set idle_timeout to ten minutes, enter either 10m or 600s:
(config)>path-paramidle_timeout 600s
(config)
The default is 15m.
11. Configure monitor settings.
a. (Optional) Enable monitoring of CTS (Clear to Send) changes on this port:
(config)>path-parammonitor cts true
(config)
IX14 User Guide
Serial port
160