Digi IX14 User Manual page 418

Services
4. For Add Multicast route, type a name for the route and click .
5. The new route is enabled by default. To disable, uncheck Enable.
6. Type the Source address for the route. This must be a multicast IP address between 224.0.0.1
and 239.255.255.255.
7. Select a Source interface where multicast packets will arrive.
8. To add one or more destination interface that the IX14 device will send mutlicast packets to:
a. Click to expand Destination interfaces.
b. Click .
c. For Destination interface, select the interface.
d. Repeat for additional destination interfaces.
9. Click Apply to save the configuration and apply the change.

Command line
1. Log into the IX14 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Add the multicast route. For example, to add a route named test:
(config)> add service multicast test
(config service multicast test)>
4. The multicast route is enabled by default. If it has been disabled, enable the route:
(config service multicast test)> enable true
(config service multicast test)>
5. Set the source address for the route. This must be a multicast IP address between 224.0.0.1
and 239.255.255.255.
(config service multicast test)> dst ip-address
(config service multicast test)>
6. Set the source interface for the route where multicast packets will arrive:
a. Use the ? to determine available interfaces:
(config service multicast test)> src_interface ?
Source interface: Where the multicast packets will arrive. IP routes
IX14 User Guide
Configure a multicast route
418