Digi IX14 User Manual page 332

Services
3. Click Services > SSH.
4. Click Enable.
5. Click Apply to save the configuration and apply the change.

Command line
1. Log into the IX14 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Enable or disable the SSH service:
To enable the service:
n
(config)> service ssh enable true
(config)>
To disable the sevice:
n
(config)> service ssh enable false
(config)>
4. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
IX14 User Guide
Configure SSH access
332