Digi IX14 User Manual page 85

Hide thumbs Also See for IX14:

Table of Contents

7. Click Apply to save the configuration and apply the change.

Command line

1. Log into the IX14 command line as a user with full Admin access rights.

Depending on your device configuration, you may be presented with an Access selection

menu. Type admin to access the Admin CLI.

2. At the command line, type config to enter configuration mode:

3. Change to the WAN or WWAN's node in the configuration schema. For example, to disable

SureLink for the Modem interface:

(config)> network interface modem

(config network interface modem)>

4. Disable SureLink:

(config network interface modem> ipv4 surelink enable false

(config network interface modem)>

5. Save the configuration and apply the change:

(config network interface my_wwan ipv4 surelink)> save

Configuration saved.

6. Type exit to exit the Admin CLI.

Depending on your device configuration, you may be presented with an Access selection

menu. Type quit to disconnect from the device.

Disable DNS lookup

Alternatively, you can disable DNS lookup or other internet activity for device that use a private APN

with no Internet access, or that have restricted wired WAN connections that do not allow DNS

resolution, while retaining the SureLink interface test. The SureLink interface test determines if the

interface has an IP address assigned to it, that the physical link is up, and that a route is present to

send traffic out of the network interface.

IX14 User Guide

Wireless Wide Area Networks (WWANs)