Digi IX14 User Manual page 425

Services
To limit access to specified IPv6 addresses and networks:
n
a. Click IPv6 Addresses.
b. For Add Address, click .
c. For Address, enter the IPv6 address or network that can access the device's iperf
d. Click  again to list additional IP addresses or networks.
To limit access to hosts connected through a specified interface on the IX14 device:
n
a. Click Interfaces.
b. For Add Interface, click .
c. For Interface, select the appropriate interface from the dropdown.
d. Click  again to allow access through additional interfaces.
To limit access based on firewall zones:
n
a. Click Zones.
b. For Add Zone, click .
c. For Zone, select the appropriate firewall zone from the dropdown.
d. Click  again to allow access through additional firewall zones.
7. Click Apply to save the configuration and apply the change.

Command line
1. Log into the IX14 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Enable the iPerf server:
(config)> service iperf enable true
(config)>
IX14 User Guide
service. Allowed values are:
A single IP address or host name.
l
A network designation in CIDR notation, for example, 2001:db8::/48.
l
any: No limit to IPv6 addresses that can access the iperf service.
l
See Firewall configuration for information about firewall zones.
Use the iPerf service
425