Firewall
3. Click Firewall > Zones.
4. In Add Zone, enter a name for the zone and click .
The firewall configuration window is displayed.
5. (Optional) If traffic on this zone will be forwarded from a private network to the internet,
enable Network Address Translation (NAT).
6. Click Apply to save the configuration and apply the change.
See
Configure the firewall zone for a network interface
network interfaces to use a zone.
Command line
1. Log into the IX14 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
IX14 User Guide
Firewall configuration
for information about how to configure
243