Digi IX14 User Manual page 431

Services
Repeat this step to list additional interfaces.
To limit access based on firewall zones:
n
(config)> add service iperf acl zone end value
Where value is a firewall zone defined on your device, or the any keyword.
Repeat this step to list additional firewall zones.
6. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
IX14 User Guide
Use ... network interface ? to display interface information:
(config)> ... network interface ?
Interfaces
Additional Configuration
-------------------------------------------
defaultip
defaultlinklocal
lan
loopback
modem
config)>
Display a list of available firewall zones:
Type ... firewall zone ? at the config prompt:
(config)> ... firewall zone ?
Zones: A list of groups of network interfaces that can be
referred to by packet
filtering rules and access control lists.
Additional Configuration
--------------------------------------------------------
-----------------------
any
dynamic_routes
edge
external
internal
ipsec
loopback
setup
(config)>
Configure the ping responder service
Default IP
Default Link-local IP
LAN
Loopback
Modem
431