Show Captured Traffic Data - Digi IX14 User Manual

Diagnostics
name: Name of the capture filter to use.
Format:
test_capture
capture_ping
> analyzer stop name

Show captured traffic data

To view captured data traffic, use the
following information for each packet:
The packet number.
n
The timestamp for when the packet was captured.
n
The length of the packet and the amount of data captured.
n
Whether the packet was sent or received by the device.
n
The interface on which the packet was sent or received.
n
A hexadecimal dump of the packet of up to 256 bytes.
n
Decoded information of the packet.
n
To show captured data traffic:

Command line
1. Log into the IX14 command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Type the following at the Admin CLI prompt:
> show analyzer name capture_filter
Packet 1 : Mar-03-2022 10:16:23.287682, Length 60 bytes (Captured Length
60 bytes)
Received on interface eth1
00 40 ff 80 01 20 b4 b6
.!.s..E.
00 28 3d 36 40 00 80 06
4a 48 cd ae 00 16 a4 4b
._...#P.
08 02 c7 40 00 00 00 00
Ethernet Header
Destination MAC Addr : 00:40:D0:13:35:36
Source MAC Addr
Ethernet Type
IP Header
IP Version
IX14 User Guide
show analyzer command. The command output show the
86 21 b5 73 08 00 45 00
14 bc 0a 0a 4a 82 0a 0a
ff 5f ee 1f d8 23 50 10
00 00 00 00
: fb:03:53:05:11:2f
: IP (0x0800)
: 4
Analyze network traffic
.@... ..
.(=6@... ....J..
JH.....K
...@.... ....
697