The Revert Command - Digi IX14 User Manual

Hide thumbs Also See for IX14:

Table of Contents

Command line interface

3. Use the show command again to verify the change:

(config)> show auth method

The revert command

The revert command is used to revert changes to the IX14 device's configuration and restore default

configuration settings. The behavior of the revert command varies depending on where in the

configuration hierarchy the command is executed, and whether the optional path parameter is used.

After executing the revert command, you must save the configuration changes by using the save

command. You can also discard the configuration changes by using the cancel command.

CAUTION! The revert command reverts all changes to the default configuration, not only

unsaved changes.

Revert all configuration changes to default settings

To discard all configuration changes and revert to default settings, use the revert command at the

config prompt without the optional path parameter:

1. At the config prompt, enter revert:

(config)> revert

2. Set the password for the admin user prior to saving the changes:

(config)> auth user admin password pwd

3. Save the configuration and apply the change:

(config)> save

Configuration saved.

4. Type exit to exit the Admin CLI.

Depending on your device configuration, you may be presented with an Access selection

menu. Type quit to disconnect from the device.

Revert a subset of configuration changes to the default settings

There are two methods to revert a subset of configuration changes to the default settings.

Enter the revert command with the path parameter. For example, to revert all changes to the

authentication methods configuration:

IX14 User Guide

Configuration mode