Example Performance Test Using Iperf3 - Digi IX14 User Manual

Services
7. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Example performance test using iPerf3

On a remote host with Iperf3 installed, enter the following command:
$ iperf3 -c device_ip
where device_ip is the IP address of the IX14 device. For example:
$ iperf3 -c 192.168.2.1
Connecting to host 192.168.2.1, port 5201
[ 4] local 192.168.3.100 port 54934 connected to 192.168.1.1 port 5201
[ ID] Interval
[ 4] 0.00-1.00
[ 4] 1.00-2.00
[ 4] 2.00-3.00
[ 4] 3.00-4.00
[ 4] 4.00-5.00
[ 4] 5.00-6.00
[ 4] 6.00-7.00
[ 4] 7.00-8.00
[ 4] 8.00-9.00
[ 4] 9.00-10.00
- - - - - - - - - - - - - - - - - - - - - - - - -
[ ID] Interval
[ 4] 0.00-10.00
[ 4] 0.00-10.00
iperf Done.
$
IX14 User Guide
Transfer Bandwidth
sec 26.7 MBytes 224 Mbits/sec
sec 28.4 MBytes 238 Mbits/sec
sec 29.8 MBytes 250 Mbits/sec
sec 31.2 MBytes 262 Mbits/sec
sec 32.1 MBytes 269 Mbits/sec
sec 32.5 MBytes 273 Mbits/sec
sec 33.9 MBytes 284 Mbits/sec
sec 33.7 MBytes 282 Mbits/sec
sec 33.5 MBytes 281 Mbits/sec
sec 33.2 MBytes 279 Mbits/sec
Transfer Bandwidth
sec 315 MBytes 264 Mbits/sec
sec 313 MBytes 262 Mbits/sec
Configure the ping responder service
Retr Cwnd
8 2.68 MBytes
29 1.39 MBytes
0 1.46 MBytes
0 1.52 MBytes
0 1.56 MBytes
0 1.58 MBytes
0 1.60 MBytes
0 1.60 MBytes
0 1.60 MBytes
0 1.60 MBytes
Retr
37 sender
receiver
432