Digi IX14 User Manual page 92

Interfaces
9. Set whether the modem should use the main antenna, the auxiliary antenna, or both the main
and auxiliary antennas:
(config)> network modem modem antenna value
(config)>
where value is one of the following:
main
n
aux
n
both
n
10. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
11. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Configure cellular modem APNs
The IX14 device uses a preconfigured list of Access Point Names (APNs) when attempting to connect
to a cellular carrier for the first time. After the device has successfully connected, it will remember the
correct APN. As a result, it is generally not necessary to configure APNs. However, you can configure
the system to use a specified APN.
To configure the APN:

WebUI
1. Log into the IX14 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
IX14 User Guide
Wireless Wide Area Networks (WWANs)
92