Digi IX14 User Manual page 415

Services
Repeat this step to list additional interfaces.
To limit access based on firewall zones:
n
(config)> add service ntp acl zone end value
Where value is a firewall zone defined on your device, or the any keyword.
Repeat this step to list additional firewall zones.
Note By default, the access control list for the NTP service is empty, which means that all
downstream hosts connected to the IX14 device can use the NTP service.
7. (Optional) Set the timezone for the location of your IX14 device. The default is UTC.
(config)> system time timezone value
(config)>
IX14 User Guide
Additional Configuration
-------------------------------------------
defaultip
defaultlinklocal
lan
loopback
modem
config)>
Display a list of available firewall zones:
Type ... firewall zone ? at the config prompt:
(config)> ... firewall zone ?
Zones: A list of groups of network interfaces that can be
referred to by packet
filtering rules and access control lists.
Additional Configuration
--------------------------------------------------------
-----------------------
any
dynamic_routes
edge
external
internal
ipsec
loopback
setup
(config)>
Default IP
Default Link-local IP
LAN
Loopback
Modem
Network Time Protocol
415