Digi IX14 User Manual page 476

Applications
i. Log into the IX14 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access
selection menu. Type admin to access the Admin CLI.
ii. At the command line, type config to enter configuration mode:
> config
(config)>
iii. Add an application entry:
(config)> add system schedule script end
(config system schedule script 0)>
Scheduled scripts are enabled by default. To disable:
(config system schedule script 0)> enable false
(config system schedule script 0)>
iv. Provide a label for the script:
(config system schedule script 0)> label "Show system application"
v. Configure the application to run automatically when the device reboots:
(config system schedule script 0)> when boot
(config system schedule script 0)>
vi. Configure the application to restart if it crashes:
(config system schedule script 0)> exit_action restart
(config system schedule script 0)>
vii. Set the command that will execute the application:
(config system schedule script 0)> commands "python
/etc/config/scripts/showsystem.py"
(config system schedule script 0)>
viii. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
b. Run the showsystem.py application. You can run the application by either rebooting the
device, or by running it from the shell prompt.
n
IX14 User Guide
To reboot the device:
i. From the WebUI:
i. From the main menu, click System.
ii. Click Reboot.
Digidevice module
476