Digi IX14 User Manual page 87

Interfaces
8. Click the menu icon (...) next to the target and select Delete.
9. Click Apply to save the configuration and apply the change.

Command line
1. Log into the IX14 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Change to WAN or WWAN's node in the configuration schema. For example, to disable SureLink
for an interface named my_wan:
(config)> network interface my_wan
(config network interface my_wan)>
4. Determine the index number of the target:
(config network interface my_wan)> show ipv4 surelink target
0
interface_down_time 600s
interface_timeout 120s
test interface_up
1
test dns_configured
(config network interface my_wan)>
IX14 User Guide
Wireless Wide Area Networks (WWANs)
87