Configure Vrrp - Digi IX14 User Manual

Routing
addition to the basic VRRP device failover. For IX14 devices,
connections.
VRRP+ can be configured to probe a specified IP address by either sending an ICMP echo request
(ping) or attempting to open a TCP socket to the IP address.

Configure VRRP

This section describes how to configure VRRP on a IX14 device.
Required configuration items
Enable VRRP.
n
The interface used by VRRP.
n
The Router ID that identifies the virtual router instance. The Router ID must be the same on all
n
VRRP devices that participate in the same VRRP device pool.
The VRRP priority of this device.
n
The shared virtual IP address for the VRRP virtual router. Devices connected to the LAN will use
n
this virtual IP address as their default gateway.
See Configure VRRP+
network probing to monitor connections through VRRP-enabled devices and dynamically change the
VRRP priorty of devices based on the status of their network connectivity.

WebUI
1. Log into the IX14 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Network > VRRP.
IX14 User Guide
for information about configuring VRRP+, an extension to VRRP that uses
Virtual Router Redundancy Protocol (VRRP)
SureLink is used to probe network
732