Routing
n
n
n
n
n
13. Click Apply to save the configuration and apply the change.
Command line
1. Log into the IX14 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Add a new routing policy:
(config)> add network route policy end
(config network route policy 0)>
New route policies are enabled by default. To disable:
(config network route policy 0)> enable false
(config network route policy 0)>
4. (Optional) Set the label that will be used to identify this route policy:
(config network route policy 0)> label "New route policy"
(config network route policy 0)>
IX14 User Guide
Interface: Matches the destination IP address to the selected interface's network
address.
IPv4 address: Matches the destination IP address to the specified IP address or
network. Use the format IPv4_address/[netmask], or use any to match any IPv4
address.
IPv6 address: Matches the destination IP address to the specified IP address or
network. Use the format IPv6_address/[prefix_length], or use any to match any IPv6
address.
Domain: Matches the destination IP address to the specified domain names. To
specify domains:
i. Click to expand Domains.
ii. Click the to add a domain.
iii. For Domain, type the domain name.
iv. Repeat to add additional domains.
Default route: Matches packets destined for the default route, excluding routes for
local networks.
IP routing
714