Digi IX14 User Manual page 146

Interfaces
1. Disable the DHCP server, if it is enabled:
(config network interface my_lan ipv4 dhcp_relay 1)> .. .. dhcp_server
enable false
(config network interface my_lan ipv4 dhcp_relay 1)>
6. Save the configuration and apply the change:
(config network interface lan1 ipv4 dhcp_relay 1)> save
Configuration saved.
>
7. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Show DHCP server status and settings
View DHCP status to monitor which devices have been given IP configuration by the IX14 device and
to diagnose DHCP issues.

WebUI
1. Log into the IX14 WebUI as a user with Admin access.
2. On the main menu, click Status
3. Under Networking, click DHCP Leases.

Command line
1. Log into the IX14 command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Enter the show dhcp-lease
> show dhcp-lease
IP Address
-------------
192.168.2.194
192.168.2.195
>
3. Additional information can be returned by using the
> show dhcp-lease verbose
IP Address
MAC Address
-------------
-----------------
IX14 User Guide
command at the Admn CLI prompt:
Hostname Expires
--------------- -------
MTK-ENG-USER1
MTK-ENG-USER2
Hostname Expires
-------- ------------------------
Local Area Networks (LANs)
show dhcp-lease verbose
Type
-------
command:
Active
------
146