Digi IX14 User Manual page 722

Routing

Command line
1. Log into the IX14 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Enable routing services:
(config)> network route service enable true
(config)>
4. Configure routing services that will be used:
a. Use the ? to display available routing services:
(config)> network route service ?
Routing services: Settings for dynamic routing services and protocols.
Parameters
---------------------------------------------------------------------
----------
enable
zone
Additional Configuration
---------------------------------------------------------------------
----------
bgp
isis
ospfv2
ospfv3
rip
ripng
(config)>
b. Enable a routing service that will be used. For example, to enable the RIP service:
(config)> network route service rip enable true
(config)>
c. Complete the configuration of the routing service. For example, use the ? to view the
available parameters for the RIP service:
(config)> network route service rip ?
Parameters
IX14 User Guide
Current Value
true Enable
dynamic_routes Zone
BGP
IS-IS
OSPFv2
OSPFv3
RIP
RIPng
Current Value
IP routing
722