Digi IX14 User Manual page 335

Services

Command line
1. Log into the IX14 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Configure access control:
To limit access to specified IPv4 addresses and networks:
n
(config)> add service ssh acl address end value
(config)>
Where value can be:
l
l
l
Repeat this step to list additional IP addresses or networks.
To limit access to specified IPv6 addresses and networks:
n
(config)> add service ssh acl address6 end value
(config)>
Where value can be:
l
l
l
Repeat this step to list additional IP addresses or networks.
To limit access to hosts connected through a specified interface on the IX14 device:
n
(config)> add service ssh acl interface end value
(config)>
Where value is an interface defined on your device.
IX14 User Guide
A single IP address or host name.
A network designation in CIDR notation, for example, 192.168.1.0/24.
any: No limit to IPv4 addresses that can access the SSH service.
A single IP address or host name.
A network designation in CIDR notation, for example, 2001:db8::/48.
any: No limit to IPv6 addresses that can access the SSH service.
Display a list of available interfaces:
Use ... network interface ? to display interface information:
(config)> ... network interface ?
Configure SSH access
335