Change The Lan Address Type - Digi IX14 User Manual

Initial configuration
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. At the config prompt, set the IP address to an alternate private IP:
(config)> network interface lan ipv4 address IPv4_address/netmask
(config)>
4. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Change the LAN address type

By default, the LAN interface uses a static IP address. To configure it to use a DHCP address instead:

WebUI
1. Log into the IX14 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Network > Interfaces > LAN > IPv4.
4. For the Type option, select DHCP address.
IX14 User Guide
Change the LAN address type
52