Configure Application Mode - Digi IX14 User Manual

b. (Optional) Enable monitoring of DCD (Data Carrier Detect) changes on this port:
(config)>path-parammonitor dcd true
(config)
12. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
13. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Configure Application mode

Application mode provides access to the serial device from Python applications.
To change the configuration to match the serial configuration of the device to which you want to
connect:

WebUI
1. Log into the IX14 WebUI as a user with Admin access.
2. On the menu, click System. Under Configuration, click Serial Configuration.
The Serial Configuration page is displayed.
Note You can also configure the serial port by using Device Configuration > Serial. Changes
made by using either Device Configuration or Serial Configuration will be reflected in both.
3. Click the name of the port that you want to configure.
IX14 User Guide
Serial port
161