Digi IX14 User Manual page 184

User authentication
Shell access is not available if the Allow shell parameter has been disabled. See
shell access
Serial access
n
6. Click Apply to save the configuration and apply the change.

Command line
1. Log into the IX14 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Enable or disable access rights for the group. For example:
Admin access:
n
l
IX14 User Guide
for more information about the Allow shell parameter.
To set the access level for Admin access of the admin group:
(config)> auth group admin acl admin level value
(config)>
where value is either:
full: provides users of this group with the ability to manage the IX14 device by
o
using the WebUI or the Admin CLI.
read-only: provides users of this group with read-only access to the WebUI and
o
Admin CLI.
Authentication groups
Disable
184