Modbus Gateway - Digi IX14 User Manual

Services
---------------
State
Source
Latitude
Longitude
Altitude
Velocity
Direction
Quality
UTC Date and Time : Thurs, 03 March 2022 10:16:23 03
No. of Satellites : 7
>
3. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Show geofence information
1. Log into the IX14 command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Use the show location geofence
> show location geofence
Geofence
-------------
test_geofence
>
3. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Modbus gateway

The IX14 supports the ability to function as a Modbus gateway, to provide serial-to-Ethernet
connectivity to Programmable Logic Controllers (PLCs), Remote Terminal Units (RTUs), and other
industrial devices. MODBUS provides client/server communication between devices connected on
different types of buses and networks, and the IX14 gateway allows for communication between
buses and and networks that use the Modbus protocol.
This section contains the following topics:
Configure the Modbus gateway
Show Modbus gateway status and statistics
IX14 User Guide
: enabled
: 192.168.2.3
: 44* 55' 14.809" N (44.92078)
: 93* 24' 47.262" w (-93.413128)
: 279 meters
: 0 meters per second
: None
: Standard GNSS (2D/3D)
command at the system prompt:
Status State Transitions
------ ------ -----------
Up Inside 0
Modbus gateway
Last Transition
---------------
390
403
389