Ix10 Power Supply Requirements; Digi Ix10 Serial Connector Pinout; 10-Pin Serial Cabling Options - Digi IX10 User Manual

Digi IX10 hardware reference
-98 < RSSI <= -89, bars=3
-104 < RSSI <= -98, bars=2
RSSI <= -104, if we're connected to the cellular network, bars=1, if not bars=0
bars is then reported as the signal strength bars.

IX10 power supply requirements

IX10 is intended to be powered by a certified power supply with output rated at either 12 VDC/0.75 A
or 24 VDC/0.375 A minimum.
Use the included power supply (part number 24000154).
n
If you are providing the DC power source with a non-Digi power supply, you must use a certified
n
LPS power supply rated at either 12 VDC/0.75 A or 24 VDC/0.375 A minimum. The voltage
tolerance supports +/- 10% (9 VDC to 30 VDC) at 9 Watts minimum.
For installations requiring protective earth grounding, connect the -ve terminal of the power
n
connector to the system protective earth with a minimum 1mm2 stranded single insulated
cable. Crimp terminals should be used for all connections.

Digi IX10 serial connector pinout

The IX10 is a DTE device. The pinout for the 10 pin RJ-50 serial connector is as follows:
Pin number
1
2
3
4
5
6
7
8
9
10

10-pin serial cabling options

Digi offers several cabling options for connecting a 10 pin RJ-45/RJ-50 serial port to DB9 and DB24
serial connectors. The
information about these cabling options. For example, Digi part number
RJ45 to DB9 female cable.
IX10 User Guide
RS485 half-
RS232 signal duplex signal
RI
DSR
RTS
GND GND
Tx TxD/RxD+
Rx TxD/RxD-
GND SG
CTS
DTR
DCD
PortServer TS, Digi Connect, and Digi One Products Cable Guide
IX10 power supply requirements
provides
76000201 provides a four foot
25