Table of Contents
Advertisement
Transport SR Series Installation Guide
In both cases, the end of the SIM card with the chamfered corner should be inserted first.
For SIM 1 the contacts should be face down. For SIM 2 the contacts should be face up.
Step 2 – Fitting the antenna
The router may be supplied with an antenna for use with wireless networks.
Attach the antenna onto the SMA connector on the rear panel of the router. DO NOT
OVERTIGHTEN THE ANTENNA – IT SHOULD BE FINGER TIGHT ONLY.
Step 3 – Connecting the LAN cable
Plug one end of one of the supplied 2 metre CAT5 cable into the RJ45 socket labelled
LAN 0. Plug the other end into the LAN socket on your PC or notebook.
Step 4 – Connecting the serial cable
For connection to a serial terminal device, connect a DB25 serial cable to the SERIAL
connector on the rear of the unit. Connect the other end of the DB9 cable to the terminal.
Step 5 – Connecting the power supply
Plug the jack plug on the power supply into the socket labelled 12V DC. When power is
first applied, the ON indicator will illuminate and the unit will initiate a series of diagnostic
self-tests. During this process one or more of the other indicators, will flash to show that
the unit is busy. When the flashing stops, the unit is ready to use.
The unit is now ready to be configured.
9
Advertisement
Table of Contents
