Ix10 Power Supply Requirements; Digi Ix10 Serial Connector Pinout - Digi IX10-00G4 User Manual

Digi IX10 hardware reference
RSSI > -80, bars=5
-89 < RSSI <= -80, bars=4
-98 < RSSI <= -89, bars=3
-104 < RSSI <= -98, bars=2
RSSI <= -104, if we're connected to the cellular network, bars=1, if not bars=0
bars is then reported as the signal strength bars.

IX10 power supply requirements

IX10 is intended to be powered by a certified power supply with output rated at either 12 VDC/0.75 A
or 24 VDC/0.375 A minimum.
Use the Digi power supply accessory kit 76002104.
n
If you are providing the DC power source with a non-Digi power supply, you must use a
n
certified LPS power supply rated at either 12 VDC/0.75 A or 24 VDC/0.375 A minimum. The
voltage tolerance supports +/- 10% (9 VDC to 30 VDC) at 9 Watts minimum.
For installations requiring protective earth grounding, connect the -ve terminal of the power
n
connector to the system protective earth with a minimum 1mm2 stranded single insulated
cable. Crimp terminals should be used for all connections.

Digi IX10 serial connector pinout

The IX10 is a DTE device. The pinout for the 10 pin RJ-50 serial connector is as follows:
Pin number
1
2
3
4
5
6
7
8
9
10
IX10 User Guide
RS485 half-
RS232 signal duplex signal
RI
DSR
RTS
GND GND
Tx TxD/RxD+
Rx TxD/RxD-
GND SG
CTS
DTR
DCD
IX10 power supply requirements
31