Disabling The Vehicle; Disconnecting The Batteries; Connecting The Batteries - Club Car IQ Plus 2008 Maintenance And Service Manual Supplement

PERIODIC MAINTENANCE
(–)
Figure 10-3 Battery Configuration (Turf 2, Carryall 2,
Carryall 6 (Style B))
(Viewed from driver side of vehicle)
1. Place TOW/RUN Switch in TOW before disconnecting or
connecting battery cables.
2. Remove negative battery cable.
3. Remove positive battery cable.
Connect battery cables in reverse order.

DISABLING THE VEHICLE

1. Set the park brake.
2. Turn the key switch OFF and remove the key.
3. Place the Forward/Reverse control in the NEUTRAL position.
4. In addition, chock the wheels if servicing or repairing the vehicle.
5. Connect the spark plug wire(s) to the spark plug(s).

DISCONNECTING THE BATTERIES

1. Disable the vehicle. See Disabling The Vehicle on page 10-3.
2. Place Tow/Run switch in the TOW position before disconnecting or connecting the batteries. Failure to
heed this warning could result in a battery explosion or severe personal injury.
3. Disconnect the batteries, negative (–) cable first, as shown (Figure 10-1, Page 10-2), (Figure 10-2,
Page 10-2) or (Figure 10-3, Page 10-3).
4. After disconnecting the batteries, wait 90 seconds for the controller capacitors to discharge.

CONNECTING THE BATTERIES

1. Ensure the Tow/Run switch is in the TOW position.
2. Connect the battery cables, positive (+) cable first.
3. Tighten battery terminals to 110 in-lb (12.4 N·m).
4. Coat terminals with Battery Terminal Protector Spray (CC P/N 1014305) to minimize corrosion.
(+)
2008-2011 IQ Plus Electric Vehicle Maintenance and Service Supplement
10
General Warning
Page 10-3