Warnings and Errors
Replace model head
•
The model head has reached 1500 build hours (odometer limit). Build hours are available
within the head's Head Details page (see
•
Correct condition - you are able to continue building using this head but it is recommended
that you change the head prior to starting a new build (see
(page
Replace support head
•
The support head has reached 1500 build hours (odometer limit). Build hours are available
within the head's Head Details page (see
•
Correct condition - you are able to continue building using this head but it is recommended
that you change the head prior to starting a new build (see
(page
Errors Preventing a Build from Starting
Printer busy
•
Indicates that the printer is in the process of completing another task and a build cannot be
started until the task is complete.
•
Correct condition - wait a couple of minutes and then attempt to restart the build.
Close the door
•
Indicates that the oven door is open.
•
Correct condition - close the oven door.
Close the cover
•
Indicates that the top cover is open.
•
Correct condition - close the top cover.
Remove the part
•
Indicates that the completed part from the previously built job is still in the printer's oven
chamber.
•
Correct condition - open the oven door and remove the completed part. See
Part from the Printer" (page 130)
Select a job
•
Indicates that a job has not been selected for building.
•
Correct condition - select the job you'd like to build from the Job Queue. See
Job to Build" (page 123)
Insert a model head
•
Indicates that a model head has not been installed into the printer.
•
Correct condition - install model head. See
instructions.
119)).
119)).
for instructions.
© Copyright 2021 Stratasys. All rights reserved.
Errors Preventing a Build from Starting
"Viewing Head Details" (page
"Viewing Head Details" (page
for instructions.
"Head Replacement" (page 119)
64)).
"Head Replacement"
64)).
"Head Replacement"
"Removing a
"Selecting a
for
Page 216