Warnings and Errors
Warnings at Build Start
Model material does not match selected job
•
The model material currently installed does not match the model material configuration of
the selected job.
•
Correct condition - unload incorrect model material and load the correct model material for
the selected job. See
for instructions.
Support material does not match selected job
•
The support material currently installed does not match the support material configuration
of the selected job.
•
Correct condition - unload incorrect support material and load the correct support material
for the selected job. See
(page 110)
Insufficient model material for part build
•
The amount of model material currently installed in the printer is not sufficient for the
selected build.
•
Correct condition - install additional model material into the printer, see
(page 110)
material spool in order to utilize the auto changeover feature or install an entirely new spool
containing enough material to complete the build. Please note that auto changeover is only
applicable for the F270 and F370 printers.
Insufficient support material for part build
•
The amount of support material currently installed in the printer is not sufficient for the
selected build.
•
Correct condition - install additional support material into the printer, see
(page 110)
material spool in order to utilize the auto changeover feature or install an entirely new spool
containing enough material to complete the build. Please note that auto changeover is only
applicable for the F270 and F370 printers.
Order new model head
•
The model head has reached 1350 build hours, and is near its odometer limit. Build hours
are available within the head's Head Details page (see
•
Correct condition - you are still able to build using this head, but part quality may be
affected. Once the head's odometer limit is reached, you will be prompted to change the
head (see
Order new support head
•
The support head has reached 1350 build hours, and is near its odometer limit. Build hours
are available within the head's Head Details page (see
•
Correct condition - you are still able to build using this head, but part quality may be
affected. Once the head's odometer limit is reached, you will be prompted to change the
head (see
"Unloading Material" (page 114)
"Unloading Material" (page 114)
for instructions.
for instructions. When installing additional material you can install a second
for instructions. When installing additional material you can install a second
"Head Replacement" (page
"Head Replacement" (page
© Copyright 2021 Stratasys. All rights reserved.
and
"Loading Material" (page 110)
and
"Viewing Head Details" (page
119)).
"Viewing Head Details" (page
119)).
Warnings at Build Start
"Loading Material"
"Loading Material"
"Loading Material"
Page 215
64)).
64)).