Rear Panel - Stratasys F123 Series Manual

Customer Replaceable Units

Rear Panel

Required Tools
• 3 mm hex wrench
Removing the Rear Panel
1. Power OFF the printer, see
2. Using a 3 mm hex wrench, remove the rear panel mounting screws (16). See
3. The rear panel has brackets that allow it to hang on the printer frame. Remove the rear
panel by lifting upward and pulling away from the printer.
Hanging Bracket
Installing the Rear Panel
1. Insert the rear panel hanger brackets into the notches in the side panels. See
2. Align the rear panel with the mounting holes in the frame. See
3. Using a 3 mm hex wrench, loosely install the rear panel mounting screws (16). See
Figure
4. Tighten the rear panel mounting screws (16).
Removal of the rear panel requires the removal of the AC power cord. Do not install
the AC power cord with the back panel removed.
Figure 23: Rear Panel Mounting Screw Locations
23.
© Copyright 2021 Stratasys. All rights reserved.
"Powering Off" (page 181).
Mounting Screws
Figure 23.
Rear Panel
Figure 23.
Figure 23.
Page 182